till it suddenly didn’t for source 2.
Ok so it is still working for source 1?
- L_Ctrl, L_Ctrl, F7 - USB 3.2 follows port selection
- L_Ctrl, L_Ctrl, U - USB 3.2 to current port
Any chance you hit one of the key combos from the manual/FAQ by accident?
The other thing it could be is there is an overcurrent e fuse in the kvm that takes a long time to clear. Like a minute. You need to unplug the kvm from USB and power and then try again if the shortcut key doesn’t fix it.
After that it would be good to try a USB thumb drive or something like that in the same port just to double confirm it wasn’t a dac firmware update or software change thats cropped up.
After all that you can email me and I will be glad to help you setup an RMA where you can mail it in for repair. 99/100 times the USB ports are fine though; the symptoms don’t seem like hardware esp if port 2 works but not 1.