USB-C to DisplayPort

KVM Model:

1.4 Display Port KVM Switch - Dual Monitor - Two Computer

USB Interface (5-gigabit or 10-gigbit):

5-gigabit


Problem:

I’m trying to use a USB-C (computer) to displayport (monitor) cable. The cable works when going directly to the monitor, but with the KVM in the middle there is no signal. Are there compatibility issues when using this configuration?

Other Notes:

type here

You have the cable info?

Defiinitely give us your specs and cable info. From what? To what monitor?

It’s a Cable Matters 54Gbps USB C to DisplayPort 2.1 Cable, DP54

Can’t post a link but it’s available on Amazon.

If you have this cable, where does the combiner fit in?

Edit: Oh I thought this was a combiner post for a sec. I’ll elevate your permissions.

The flow is PC (USB-C) → KVM (Displayport in/out) → Monitor

BTW, monitor is a Gigabyte 28U.

Can you send a pic of the back of the KVM so I can see how everything is plugged in?

Here’s the back of the KVM, computer is on the left. One cable is unplugged in this photo since I was trying out just one at a time.

What DisplayPort → DisplayPort cable is going to your monitor(s)?

It’s this one: Amazon.com: Club3D CAC-2068 VESA Certified DisplayPort to DisplayPort 1.4/Hbr3 M/M Cable DP 1.4 8K 60Hz 2m - 6,56ft : Electronics

The KVM and other cables all work fine if I stick with a display port input cable

So the USBC to DisplayPort cable works from pc → monitor when it bypasses the kvm?

That’s correct. I got some other cables to try and same result. A couple of times I did get a video signal to come through but it was not stable and locked my machine up.

I’ll try adding a repeater when it arrives today.

The repeater seems to have done the trick. I installed it on the DP out from the KVM and everything has been stable. Apparently the USB-C signal wasn’t as strong as a straight displayport one.

1 Like

Can you link the one you have?