Quirky Micron 5100 PROM.2 SATA SSD

So, I somehow got Micron 5100 PRO M.2 SATA SSD (960GB)

Model: MTFDDAV960TCB

And, it has tendency to fall into Security Protection mode. It restores operation after I perform format by Flex Capacity™ change with msecli

First I guessed that it may be defective, searched alot, found some reports of similar issue for some HP servers and even updated firmware.
But then I figured out. It never go into protection state while it just seats inside PC and used for stuff.
It goes in it if I pull it out and connect to something else, for example USB adapter (it works in adapter but after disconnected boom its locked)
So I assuming it is actually totally “fine” but somehow reacts to some modes of power loss or platform change? Looking for any insides on the matter really.

  1. May be a way to unlock it without loosing data?

  2. I noticed lots of options related to power in msecli - maybe this behavior somehow configurable? Maybe it expects some server motherboard special stuff to happen?

  3. Maybe I can flash it with some OEM firmware for more consumer friendly behavior?

i noticed that my crucial m.2s count up their “unsafe shutdown” values in smart in external enclosures. Reminds me a bit of this.

No protection of course, consumer drives.

How exactly are you clearing the protection?

Reformatting by msecli -M -O

Was unable to find any other way, but it may exist :thinking:

It has this capacitors battery, so I assume it should handle power loss, but probably in some weird way. Hm, it may be as well flash area where it dumps ram content is damaged (but I do not know how to confirm/test this).
SMART reports everything fine except 3 relocated blocks (expected?), nothing changes much in counters. I need to reinspect SMART…

1 Like

UPD.

I confirmed that turning Laptop off by pressing power button also locks this SSD.

I tried to set ATA security password to see if this changes anything - it works (also laptop bios unlock stuff), until SSD goes into this strange locked state.

Attempts to unlock with hdparm gives same results (SG_IO: bad/missing sense data (some hex nonsense that looks like translate to invalid request)