[Pre-purchase] DP 1.4 KVM for LG 34WK95U-W (5120×2160@60Hz) — transparent signal passthrough or active chip?

KVM Model:

Not yet purchased — looking for advice before buying

USB Interface (5-gigabit or 10-gigbit):

Not yet decided — open to either


Problem:

I’m trying to find out if the L1T DP 1.4 KVM will work with my specific setup before buying. My monitor is an LG 34WK95U-W (5120×2160@60Hz via DP 1.4, HDR) which is an unusual VESA timing. My key question is whether the KVM passes the DisplayPort signal transparently (pure mux) or whether there is an active chip in the signal path that needs to recognise the resolution — because if it’s the latter, 5120×2160 may not be in its lookup table.

Other Notes:

Peripherals that need to work fully (not just basic HID):

  • Corsair K100 Air Wireless RGB (I noticed Corsair is listed as problematic with hotkeys — is there a workaround?)

  • Logitech MX Master 4

  • 3DConnexion SpaceMouse Enterprise

  • Elgato Stream Deck XL

Switching between Windows 11 and Manjaro Linux. Has anyone run this monitor or any other 5120×2160 panel with an L1T KVM successfully?

Not that I know of. It will probably have to be plugged into the blue port. Most of these USBs seem like they would not be very HID-compliant. You can always use a macroboard for hotkeys, and a USB 3.2 hub to expand into more ports.

We have had success reports with high resolutions with our DisplayPort KVM: