Pi CM5 w/ Exaviz Cruiser - Getting into an OS

Hello, I’m trying to get Pi OS running on an Exaviz Cruiser board with a Pi CM5. Apparently, the SD card slot isn’t enabled on these unless you have the Lite CM5 variant. I’m unfamiliar with how else to boot into an OS on a Pi, as I’ve never used a CM before.

Their documentation recommends an M.2, but this specific build is for an NVR and I’m utilizing that slot for a Halo accelerator already. Is there a way to boot from USB natively?

Pi5 should support booting from usb natively. It will go for emmc→nvme→usb. However:

Maybe you’ll get the race condition of the bootloader dropping to USB before the drive could initialize. You’d need to do a jumper on the official cmio boards for this, but it doesn’t appear to be the case for your (very cool!) carrier board.

2 Likes

I was able to get into Pi OS via USB boot! Now, I just need to figure out how to migrate the install to the CM5’s eMMC

Oh, I see, you want to install to the emmc. I was thinking you just wanted to run the boot drive as a usb device (which may be easier since it looks like, ridiculously, you can’t install to emmc without an rpi cmio board…):

you might have luck asking for help here, seems Mr. Geerling has one of these

However if you can boot into a working system I wonder if you couldn’t just mount the emmc and then repeat the install process from the command line with the emmc as a target…

You and I have the same thought process, going to be exploring this as a possible solution!

1 Like