I was getting the network dropping out when tranfering files between my computers.
Enabling and disabling the adpater, would restore the function.
Setting up like this its now stable and I can get about 7Gbs downloads and 2.5Gbs uploads with iperf3
Is there some settings that I should switch back on to get higher performance?
I have the following settings:
DisplayName DisplayValue
Energy-Efficient Ethernet Disabled
Flow Control Disabled
Interrupt Moderation Enabled
IPv4 Checksum Offload Rx & Tx Enabled
Jumbo Packet Disabled
Large Send Offload V1 (IPv4) Disabled
Large Send Offload V2 (IPv4) Disabled
Large Send Offload V2 (IPv6) Disabled
Maximum number of RSS Queues 4 Queues
ARP Offload Enabled
NS Offload Enabled
Priority & VLAN Priority & VLAN Enabled
NDIS QoS QoS Enabled
Receive Buffers 512
Recv Segment Coalescing (IPv4) Disabled
Recv Segment Coalescing (IPv6) Disabled
Receive Side Scaling Disabled
Speed & Duplex Auto Negotiation
TCP/UDP Checksum Offload (IPv4) Disabled
TCP/UDP Checksum Offload (IPv6) Disabled
Transmit Buffers 2048
Wake on Magic Packet Disabled
Wake on Pattern Match Disabled
Downshift retries 4
Interrupt Moderation Rate Adaptive
Log Link State Event Enabled
Locally Administered Address
VLAN ID 0
Wake from power off state Enabled
Wake on Link Disabled
Wake on Ping Disabled