How hard is it to use tftp?

I’m trying to and severely failing at trying to use tftp to flash a dd-wrt firmware to a Netgear 6400

Using Linux mint debian edition on an L380 ThinkPad with a USB to Ethernet hub

I’m assuming I’m missing something like a resolver for the ip addresses given its meant to be done disconnected from the internet

What are the errors you’re having ? Can you specify it to connect to the tftp based on the IP, then you don’t need a resolver.

The resolver is not the missing piece. That Netgear recovery listener sits at 192.168.1.1 and does not offer DHCP, so the USB ethernet comes up with no address that can reach it.

Set that port to 192.168.1.2/24 by hand, leave only that cable connected, then tftp 192.168.1.1, binary mode, and put the .chk while the router is in recovery. If a ping to 192.168.1.1 fails first, the put will too.