Received pretty much every parts, except the riser cable, so I was able to at least begin to lay out how I would do the mod.
Testing everything, it boots and everything works. Luckily, the BIOS version on the mobo was recent enough to accept a 5000s CPU, so I could update the bios to the last version. Downside, the ram does not have the clocks the guy said it had. A bummer, but I cannot complain too much for the price. I will try to manually overclock the ram.
The InWin Chopin is much tighter than I expected. Just putting the mobo was quite a delicate thing to do. I was very happy that the mobo had an integrated IO shield. ![]()
Between the mobo and the PSU, there is barely like 2 mm of clearance. So the PCIe riser would need to be routed first and it will be squeezed between the two components.
I was thinking about making an opening right at the bottom to pass through to the back side, but seeing how propped up is the mobo, I will instead pass the riser cable behind the mobo and do an opening at the top instead.
This way it will help also for the GPU clearance, because with only a piece of paper, the GPU is already flush with the side. The PCIe slot is slightly too large. So it’s better to do not add height by passing a riser cable behind, even if I will do an opening in front of the GPU and put mesh in the same fashion as on the CPU side, which would help to gain some height clearance.
Looking forward to potentially cut some stuff tomorrow.
And for @E-Wasted, some pics of the Noctua fan












