@adman-c @mutation666
I ended up getting a r710 because the seller was more reputable than the r610 offerings.
I tried setting it up today, but couldn’t access the management portal using the steps listed here
To do this, I connected the Ruckus AP to a PoE injector using an Ethernet cable, and then connected the other end to my computer. I set a static IP on my computer as 192.168.0.100 with subnet mask 255.255.255.0 (the router can be empty or 192.168.0.1). You can also use any other IP in the 192.168.0.0/24 range, except 192.168.0.1, as the Ruckus AP will use that IP. Then, I reset the AP to factory settings by pressing the reset button for 10 seconds, which lets me log in with the default credentials later. The LED flashes red, orange, and yellow while holding the button and turns red after releasing it. The AP should finish booting after a minute.
Is my poe switch not able to power the r710? The product title says 802.3af PoE. The internet/chatgpt also says that it should work in poe mode, and the preformance drop off isn’t as extreme for home use. The only concern I have is if channelfly is degraded if I don’t get poe+, as my building is pretty noisy.