A few parts for my ryzen build.
I had ABS printing really well, could barely see layer lines on the face that was printed on the glass, but it needs to run too hot for this little heated bed. it was taking an hour or more to get to temp. I had a number of failures last night & switched back to PLA, as it was just wasting too much time between attempts.
This one is a pump cover prototype to test the concept, I need to see if the paint will cover up the LEDs, or if I need to print thicker. It should be ok, as my first attempt has turned out pretty good. This one is PLA.
First finished component
Printed in ABS, its so much neater than the PLA, too bad it's such a bitch to use.