So I've been looking at some cases for several months now as my current Haf 912 is just to small for me to fit everything I have. I would like to know if its possible to mount a h100i in a push pull with four 120mm fans using the forward top fan mounts of the case without the ram getting in the way. Currently im unable to even mount a single fan on the top back fan mount beacuse the motherboard i have which is a asus maximus iv extreme z have the 8 pin cpu power connector at the very top left of the board which makes it impossible to mount anything more then the radiator as seen in the bottom of the picture below (yes i know the cable management it bad but honestly i don't really care.) Due to this i have two fans attached to the outside of the case to help with heat management. So does anyone know if it will fit?
https://www.dropbox.com/s/d21nagvup0ioeed/Photo0193.jpg?dl=0 (picture of the inside of the case).
The Enthoo Pro will be able to fit all of the components you specified, it might be possible to avoid RAM conflicts by placing the h100i in the top front fan mounts but I am unsure as I do not have an h100i to test in my Enthoo Pro. Everything else will fit perfectly fine but you should consider getting an 8-pin CPU extension as I found my 8-pin to be a bit too short to reach the connector of my motherboard. Also if you can spend the extra money I would highly recommend the Enthoo Luxe (same base frame as the Pro but it has the ability to add fans above the frame, whilst still being under the bezel, to support thicker radiatiors) as that will without any doubt fit absolutely everything no problem, but the Pro is still a great case and I love it to death
I do have a 8 pin extension available so that is not a concern. Right now im not really able to afford much the enthoo pro is at the very top of my budget with college and all i cant go much higher. Thank you for the information though ill definitely be buying the case soon.