Hey all,
I've been asked to build a non-critical device for a tractor - if it fails, no big deal, but I would rather it didn't.
I'm looking for decent, cheap methods of mounting a pcb and arduino to a project box and then said box to a vehicle. In particular, I'm searching for a way to protect the components from the vibration of the vehicle and the bumps and jolts encountered when driving over rough terrain.
I haven't found a good project box yet either. I'm looking in the 10" x 5" x 4" (L x H x D) range, and once again, cheap but durable. I have to also be able to make a hole of sorts in it for a 4-segment LED display.
I'd like to keep the combined cost below $20.
Anyone have good experience with particular products? Suggestions?