Hi all, managed to boot to windows 10 and have everything setup. Installed 256gb KSM32RD4/64HAR of ram but only 128gb usable. I have swapped the slots around too see if it works but nothing although the system still detects 256gb. regardless of whichever slots i use.
Have emailed gigabyte about it but they asked “Was Windows 10 newly installed on this board? You should delete all the old Windows partitions while reinstalling Windows. Did you install the AMD Chipset drivers from this model’s Support website?”
Since this is a new board and storage there isnt and old windows partition. Also chipset has been updated.
Trying to update firmware and maybe bios to see if it resolves the issue.
And so Ive tried retrieving my ip address to access the ipmi. But doesnt show on bios even after changing from dynamic to static and back again.
Can also adjust dhcp pool to way smaller range of like 5 address or w/e and then just try them all. (not sure what his scope is or how many devices are on the network)
Could be bad mounting of the cpu (not aligned perfectly)
I’d also ask about the memory, does every stick work, but each is only detected at half capacity? Or does it go Up to 128gigs, then nothing else after?
Can you explain that? The BIOS says it only sees 128?
Where? BIOS? IPMI? Windows?
Eh? How did you update the chipset?
You can determine if you have bad sticks - just add one DIMM at a time.
Finding the IP for the machine is relatively straight forward - how are IPs handed out on your network? If the router doing that work? If it is, look at the table of IPs it has leased out. I’m assuming the motherboard has a heartbeat even if the machine is booted up, correct? It’s the light that flashes on and off between PCIe 2 and 3 on the left of the board with the CPU at the top orientation.
Every stick was detected, and the ram slots has no issues i supposed. I checked with task manager. When you hover your mouse slots used: 4 of 8 they will show which slots are used out of the 8.
Yeah i know, I was following a build by @buildorbuy ( AMD Threadripper Pro WRX80 Workstation Build Specifications) on YouTube, and it seems pretty good!
Finding the IP for the machine is relatively straight forward - how are IPs handed out on your network? If the router doing that work? If it is, look at the table of IPs it has leased out. I’m assuming the motherboard has a heartbeat even if the machine is booted up, correct? It’s the light that flashes on and off between PCIe 2 and 3 on the left of the board with the CPU at the top orientation.
I tried the couple ip address i can find and still cant get in ipmi. Will try to figure when i have more time.. Not great with technical stuff, will take some time to understand and figure. Appreciate the advise and help tho. You guys are so kind