Hi,
Context: Updating my Freenas build and I purchased Supermicro X8SAX (with Xeon X5660). The board doesn't have on board graphics so I purchased an ATI VGA card.
I tried the card with the Super Micro board and it seems to boot (fans running etc) but the GPU doesn't seem to output anything.
I tried the graphics card in my PC (built around Asus Z97 Deluxe) and seemed to have the same issue, everything powers on but doesn't boot/post (VGA LED light stays on after cycle). Leaving the ATI card installed, I connected a monitor to the MOBO and managed too boot into Windows. The card showed up in device manager and after 5 mins the drivers had installed and I could use the card to power a second display no problem.
The Super Micro MOBO also doesn't seem to be giving any "beeps", which I would expect in this situation. I've tried clearing the CMOS and I am now digging through the manual for clues..
It may be worth mentioning that I tried my Asus 1070 with the SuperMicro board and couldn't get that to work either. However I suspect that might be because I don't a 4 pin power connector for the PCI slots socket.
Here is the Manual for the SuperMicro Board if it helps: Manual
Any ideas?
Cheers,